Experimental investigation of effects of cutting parameter on MRR for EN-42 on WEDM using Taguchi Method

Authors

  • Azad Kumar Department of Mechanical Engineering, MIET, Haryana, India Author
  • Jitender Panchal Department of Mechanical Engineering, MIET, Haryana, India Author
  • Deepak Garg Department of Mechanical Engineering, Mahabir Engineering College, Ambala, India Author

Keywords:

Surface roughness, MRR, wire electrical discharge machining, EN-42, Taguchi technique, ANOVA.

Abstract

This research work presents influence of process parameters on surface roughness and material removal rate (MRR) while wire electrical discharge machining of EN-42. Experiments have been conducted with four process parameters viz., pulse on time, pulse off time, peak current and wire feed rate. Taguchi’s orthogonal array (L16) was employed for experimental investigation. ANOVA analysis was used to determine most significant factors affecting the machining performance.

References

Downloads

Published

2017-04-30

Issue

Vol. 7 No. 2 (2017)

Section

Articles

How to Cite

Experimental investigation of effects of cutting parameter on MRR for EN-42 on WEDM using Taguchi Method. (2017). International Journal of Current Engineering and Technology, 7(2), 596-599. https://ijcet.evegenis.org/index.php/ijcet/article/view/2182